CN 丨 EN
National Service Hotline:13790556503
Your current location:News >> Industry news >> Drowse
News
Contact us
Contacts:Mr. Zhang
Mobile phone:13790556503
    13712742219
Tel:0769-81152520
Address:F3 Hongan Road, Wusha Caiwu Industrial Zone, Chang'an Town, Dongguan City
Industry news
How to Deal with Common Faults of Surface Grinding Machine
Time:2019/1/22 15:12:33  Browse:times

1、Gold seepage of dust-proof plate at both ends of worktable is usually caused by improper assembly of surface grinder. The screw fixing the gold of dust-proof plate pierces both ends of the guide rail and seeps oil directly from the guide rail. The solution is to wrap the screw of the surface grinder with raw rubber tape and put it in again.

2、When the oil volume is adjusted too much, the oil tank cover is opened and the oil valve switch is adjusted with a screwdriver, clockwise for small, and conversely for large. The general control of oil volume is to lock clockwise and then rotate for 1/4. The oil groove on the wear-resistant sheet of the guide surface grinder has not been opened well, it is too shallow or not in place, and the oil can not escape from the side, it should be re-opened; the oil hole is blocked, the oil is forced out of the guide rail, the oil hole blocked is generally caused by too sticky or too dirty oil, change the oil type or clean up the lower oil road, if the old surface grinder is generally too dirty oil road blocked, clean up and change the oil can be done.

3、The front and rear screw oil leakage, if the new surface grinder oil leakage, is generally not installed before and after the expansion sheath of the screw, the two ends of the screw is not locked or the sealant is not good, if the old surface grinder is to replace the screw sheath, re-sealant.                   

Copyright © 2019  Dongguan Lanyue Machinery Technology Co., Ltd.    Technical support:Easy access network

Online QQ
Mobile phone

Mobile phone

TOP